Button Accessories

Rubber base with self-adhesive layer, affixes to underside of button. Available in lightweight non-slip sponge rubber or heavy solid rubber.

Click here to read more

M-F extension wires which can be used to extend RGB LED wiring or trackball wiring (2 req for trackball).

Click here to read more

Black top which replaces standard if the button surround is only required to illuminate. Note: For best results the locking tabs can be cut from each side to improve light distribution. The cap still stays attached.

Click here to read more

Round Pre-cut Inserts, fit between lens and lens cover. packs available, Start1,2 and Start3,4,Coin ($), Admin (pause, go, stop, volume)


Click here to read more

Harness with 32 push-on connectors. Ideal for wiring control grounds, LED power and ground. Can be cut to length. Note all our controls require the 4.8mm connector version.

Click here to read more


Pack of 100 crimp push-on "disconnect" connectors


Click here to read more