Button Accessories

Harness with 32 push-on connectors. Ideal for wiring control grounds, LED power and ground. Can be cut to length. Note all our controls require the 4.8mm connector version.

Click here to read more

Round Pre-cut Inserts, fit between lens and lens cover. packs available, Start1,2 and Start3,4,Coin ($), Admin (pause, go, stop, volume)


Click here to read more

Pack of 100 crimp push-on "disconnect" connectors


Click here to read more

Black top which replaces standard if the button surround is only required to illuminate. Note: For best results the locking tabs can be cut from each side to improve light distribution. The cap still stays attached.

Click here to read more

Round Pre-cut Inserts and clear replacement caps for Goldleaf RGB buttons.

Start1,2 and Start3,4,Coin ($), Admin (pause, go, stop, volume)Round Pre-cut Inserts, fit between lens and lens cover. packs available, Start1,2 and Start3,4,Coin ($), Admin (pause, go, stop, volume)


Click here to read more


M-F extension wires which can be used to extend RGB LED wiring or trackball wiring (2 req for trackball).

Click here to read more

Rubber base with self-adhesive layer, affixes to underside of button. Available in lightweight non-slip sponge rubber or heavy solid rubber.

Click here to read more