Look great when they are not illuminated, Fabulous when they are! Standard 30mm mounting hole Low profile. Surround only 3.8mm above panel Switches have stepped tags, suitable for 6mm (1/4in) or 4mm quick-disconnects. Bayonet-fit LED housing. Bright 5 volt or Super-Bright 3-chip 12 Volt LED option Custom-designed LED lamps with integral wide diffuser Switches from the most respected manufacturer of arcade controls

	5 Volt High Intensity LED lamps
	12 Volt Super-Bright Tri-Inverted-cone LED lamp. 15% brighter.		Optional daisy-chain harness. Use for supply and ground (permanently lit) or for supply when using Pac-Drive. Saves crimping/stripping. 28 connectors, can be cut if required.
Logo Inserts available

Lighting your pushbuttons.
LEDs can be connected to our Pac-Drive output driver board. This will be supported by several Front End menus such as Mala, to control pre-set flash sequences and illuminate the buttons used in each game.

Or you can simply light all controls permanently. Just connect all LEDs to a 5 volt or 12 volt source, depending on the LED type. No need to worry about resistors etc, the LED lamps are designed to be directly connected to the power source.
You can take power from a PC disk drive connector. The red wire on these connectors carries 5 volts, yellow is 12 volts and black is Ground.
Wiring can be done in minutes quick using our pre-made Daisy-Chain Wiring Harness.