2
1







New!

Xinput adaptor

I-PAC Xbox 360-PS3-Xinput Adaptor

This adaptor works ONLY with the 2015 I-PAC 2 board which has the new high-speed Pac-Link Expansion Interface

Xinput adaptor

Features

  • Operates in either Xinput/Xbox 360 mode or PS3 mode. Switchable on the adaptor
  • Uses a high-speed interface from the I-PAC. No lag
  • Works on the Xbox 360 without the need for a wired controller to be cross-plugged unlike many other adaptors
  • Operates in 4 control modes which can be switched on the fly from the control panel
  • One I-PAC 2 board supports one or two adaptors

Installation


The I-PAC 2 board needs to be connected to a PC and the WinIPACV2 program run, and select the "config" tab, then check the "Enable Expansion Interface" check box and click "apply".
Connect the adaptor(s) as shown in the picture below. The wire colors RED and BLACK are marked on the board on the P1 side. The P2 side connects the same way.
Connect the USB cables to the console (or PC for Xinput Mode). Note you can connect the board to a console AND to a PC using its standard USB cable at the same time.
If using on a PC in Xinput (Xbox360) mode, install the Xbox 360 Controller Drivers from Microsoft.
Depending on your panel layout and requirements you may need to change the default control mappings. The steps to do this are as follows:
  • Decide which type of console or Xinput control you need to assign or move
  • Look at the tables below to find this control, and make a note of the keycode which generates it.
  • Assign this keycode to the pin on the I-PAC which the physical control is connected to. This is done using the WinIPACV2 program.

xinput adaptor


Hotkeys for Switching Modes
 Switch to Digital Mode Start1/P1 Down* P
Switch to Left Analog Mode Start1/P1 Left* Enter
Switch to Right Analog Mode Start1/P1 Right* Tab
Switch to 2 into 1 Mode Start1/P2 Down** F12

* These are I-PAC shift functions, ie hold down P1 Start
** This is not part of the default I-PAC codeset. The function is suggested only
and can be programmed into the I-PAC if needed.
Digital Mode
     PLAYER 1    PLAYER 2
PS3 Control X-Box/Xinput Control I-PAC Button Keyboard Char I-PAC Button Keyboard Char
D-Pad Right D-Pad Right P1 Right Right P2 Right G
D-Pad Left D-Pad Left P1 Left Left P2 Left D
D-Pad Up D-Pad Up P1 Up Up P2 Up R
D-Pad Down D-Pad Down P1 Down Down P2 Down F
Start Start P1 Start 1 P2 Start 2
Select Back Start1/Up* P   F11
Left Rear Button 1 Button A P1 SW 1 L-Ctrl P2 SW 1 A
Button Square Button B P1 SW 2 L-Alt P2 SW 2 S
Button Triangle Button X P1 SW 3 Space P2 SW 3 Q
Right Rear Button 1 Button Y P1 SW 4 L-Shift P2 SW 4 W
Button X Black P1 SW 5 Z P2 SW 5 I
Button O White P1 SW 6 X P2 SW 6 K
Left Rear Button 2 L-Trigger P1 SW 7 C P2 SW 7 J
Right Rear Button 2 R-Trigger P1 SW 8 V P2 SW 8 L
L thumb click L-Analog Click Coin 1 5 Coin 2 6
R thumb click R-Analog Click   7   8
Home F1 F2
Left or Right Analog Modes
    
 PLAYER 1 PLAYER 2
PS3 Control X-Box/Xinput Control I-PAC Button Keyboard Char I-PAC Button Keyboard Char
Analog Right Analog Right P1 Right Right P2 Right G
Analog Left Analog Left P1 Left Left P2 Left D
Analog Up Analog Up P1 Up Up P2 Up R
Analog Down Analog Down P1 Down Down P2 Down F
Start Start P1 Start 1 P2 Start 2
Select Back Start1/Up* `(key below ESC)   F11
Left Rear Button 1 Button A P1 SW 1 L-Ctrl P2 SW 1 A
Button Square Button B P1 SW 2 L-Alt P2 SW 2 S
Button Triangle Button X P1 SW 3 Space P2 SW 3 Q
Right Rear Button 1 Button Y P1 SW 4 L-Shift P2 SW 4 W
Button X Black P1 SW 5 Z P2 SW 5 I
Button O White P1 SW 6 X P2 SW 6 K
Left Rear Button 2 L-Trigger P1 SW 7 C P2 SW 7 J
Right Rear Button 2 R-Trigger P1 SW 8 V P2 SW 8 L
L thumb click L-Analog Click Coin 1 5 Coin 2 6
R thumb click R-Analog Click   7   8
Home F1 F2
2 Into 1 Mode (One player uses entire 2-player panel)
     PLAYER 1
PS3 Control X-Box/Xinput Control I-PAC Button Keyboard Char
L-Analog Right L-Analog Right P1 Right Right
L-Analog Left L-Analog Left P1 Left Left
L-Analog Up L-Analog Up P1 Up Up
L-Analog Down L-Analog Down P1 Down Down
R-Analog Right R-Analog Right P2 Right G
R-Analog Left R-Analog Left P2 Left D
R-Analog Up R-Analog Up P2 Up R
R-Analog Down R-Analog Down P2 Down F
Start Start P1 Start 1
D-Pad Right D-Pad Right P2 SW 1 A
D-Pad Left D-Pad Left P2 SW 2 S
D-Pad Up D-Pad Up P2 SW 3 Q
D-Pad Down D-Pad Down P2 SW 4 W
Select Back Start1/Up* `(key below ESC)
Left Rear Button 1 Button A P1 SW 1 L-Ctrl
Button Square Button B P1 SW 2 L-Alt
Button Triangle Button X P1 SW 3 Space
Right Rear Button 1 Button Y P1 SW 4 L-Shift
Button X Black P1 SW 5 Z
Button O White P1 SW 6 X
Left Rear Button 2 L-Trigger P1 SW 7 C
Right Rear Button 2 R-Trigger P1 SW 8 V
L thumb click L thumb click Coin 1 5
R thumb click R thumb click 7
Home F1


The following adaptors are still available although stock is limited. These only function with pre-2015 I-PAC boards which have PS/2 support:

Click here for full details of the I-PAC XBOX Classic Control and AV Adaptors
Click here for full details of the I-PAC PS2 Control and AV Adaptors